Tripp Lite PowerVerter APS Instrukcja Właściciela Pobierz pdf (Strona 7)

Set Battery Charge Conserver (Load Sense) Dial—OPTIONAL

In order to save battery power, the unit’s inverter automatically shuts off in the absence of any power demand from connected

equipment or appliances (the electrical load). When the unit detects a load, it automatically turns its inverter function on.

UsersmaychoosetheminimumloadtheInverter/ChargerwilldetectbyadjustingtheBatteryChargeConserverDial(see

diagram).Usingasmalltool,turnthedialclockwisetolowertheminimumloadthatwillbedetected,causingtheinverter

to turn on for smaller loads. When the dial is turned fully clockwise, the inverter will operate even when there is no load.

Turn the dial counterclockwise to increase the minimum load that will be detected, causing the inverter to stay off until the

new minimum load is reached.

Note: the factory setting for the dial is fully clockwise. However, based on the threshold load to which you’d like the inverter to respond, you should adjust the dial counterclockwise to reduce its

sensitivity until the inverter is active only when connected equipment or appliances are actually in use.

Connect Remote Control—OPTIONAL

Modelfeaturesa8-conductortelephonestylereceptacleonthefrontpanelforusewithanoptionalremotecontrolmodule(TrippLitemodel

APSRM4,soldseparately).TheremotemoduleallowstheInverter/Chargertobemountedinacompartmentorcabinetoutofsight,while

operated conveniently from a remote location. See instructions packed with the remote control module.

Connect Battery Temperature Sensing Cable—OPTIONAL

Thebatterytemperaturesensingfunctionprolongsbatterylifebyadjustingthechargefloatvoltagelevelbasedonbatterytemperature.

Connectthesensorcable(thecable,soldseparately,hasanRJstyleconnectorononeendandablacksensorontheother)totheRJstyle

jacklocatedontheside

oftheInverter/Chargerlabeled“RemoteTemp.Sense.”Withuser-suppliedelectricalorducttape,affixthesensor

to the side of the battery below the electrolyte level. Make sure that nothing, not even tape, comes between the sensor and the side of the

battery. To guard against false readings due to ambient temperature, place the sensor between batteries, if possible, or away from sources

ofextremeheatorcold.Ifthesensorcableisnotused,theInverter/Chargerwillchargeaccordingtoitsdefault25ºCvalues.

Configuration (continued)

1 2 3 4 5 6 7 8 9 10 11 12

Komentarze do niniejszej Instrukcji

Brak uwag

Tripp Lite PowerVerter APS Instrukcja Właściciela Strona 7

Komentarze do niniejszej Instrukcji

Powiązane produkty i podręczniki dla Zasilacze i falowniki Tripp Lite PowerVerter APS